Click

Grapple, Boom 8' (Diverse Specialties Boom Grapple)



Safety Information

he Boom Grapple should only be placed on machines with a longer wheel base or track machines – preferably with enclosed cabs. The Boom Grapple should only be operated by qualified and experienced skid steer or tractor loader operators. Seat belts should be worn, even with the safety bar down. Hard hats and safety glasses should always be worn.

When attaching the Boom Grapple to the skid steer, always make sure the attachment pins and dogs are properly secured. The bottom plate of the Boom Grapple is deliberately designed to ground when the skid steer arms are down. This feature will help to stabilize the machine and slow forward tip motion if the load is too heavy. The Boom Grapple’s capabilities are dependent upon the lift capacities of each machine. If a load cannot be boomed in, you are probably exceeding the capacity of your machine. The operator should carry the load low and ALWAYS BE PREPARED TO DROP THE LOAD IF THE MACHINE BECOMES UNSTABLE. All loads should be boomed in and kept as low as possible when transporting. NEVER GO EITHER BACK OR FORWARD , UP OR DOWN STEEP SLOPES WITH RAISED LOAD. SIDE SLOPES ARE ALSO DANGEROUS. When booming out to dump load in trailer or truck, be close enough to drop load or use the side of the truck or trailer for stabilization should machine feel unstable.

When using the Boom Grapple for ditch or pond bank work, avoid areas where your machine can get stuck. The Boom Grapple, unlike a bucket, is not designed to push a stuck machine free. Neither was the Boom Grapple intended for sideways pushing, pulling or lifting.

As with any excavator, backhoe, crane or boom machine, EXTREME CAUTION should be exercised when operating in the vicinity of electrical power lines.

Under NO CIRCUMSTANCES should anyone get under or allow someone else to get under a load.

To use the boom without the grapple, remove the hydraulic hose from quick release rings and main 1” boom bolt. Add a clevis or other means of attachment through this hole.

When lowering the Boom Grapple to unhitch, skid steer arms may need to be slightly raised, which still allows the cab door to open. Plate can also be used for leveling ground. Loading and unloading your skid steer with the Boom Grapple attached onto a trailer for transport should be done with boom out and down, slowly and carefully.

Diverse Specialties, Inc. shall not be liable for incidental or consequential damages. Upon purchase, the buyer assumes all liability for personal injury and property resulting from the handling, possession and use of the goods by the buyer.

1 YEAR WARRANTY ON MANUFACTURER DEFECTS


We know your business success depends on reliable quality equipment and parts to continue being a leader in your industry. When you want Genuine Diverse Specialties, Inc original equipment parts, accessories and equipment you can always depend on Discount-Equipment.com to come through with the genuine o.e.m. products you need as quickly and inexpensive as possible. Our sales staff combined experience consists of over 90 years in the construction parts and equipment industry. We have over 1 million items online, if you are having trouble finding your item, we also have the resources to help you find what you need, our industry leading web site includes thousands of parts and service manuals available to look up your items. If you don't find what you are looking for please fill out our parts request form here.





Power Trowels

Picture of Walk Behind Power trowel

Shopping Cart

Quote Queue

Skyjack Pipe Rack

JLG FT140 Vertical LiftPod Personal Portable Lift (P/N 1001180707)

Morrison 23903 Kit 8' Uni - Screed Blade 2.4M Bartell

JLG Dual Fork Positioning Carriage, 50 in. (12,000 lb max. capacity (1255)

Trailer, 7-Ton 16' Flatbed, Electric Brakes (Loader Toter DT)

822784GT CONTRL BOX 50HZ MH 7KW Terex AL4 Light Tower

15010-H HATZ 1D42Z DIESEL, LESS WIRING HARNESS Genuine OEM Small Line Parts

Morrison 0MS40050 MS40C 5FT Frame Section Bartell

Koshin SERM-50V 2" High Pressure Pump Mitsubishi Engine **THIS MODEL IS NO LONGER AVAILABLE**

42324 15200 Gasket Airman SDG40S-8B1 Generator

18000-N INPUT SHIMS (KIT CONTAINS 3 ) Genuine OEM Small Line Parts

Skyjack 360 Ah Batteries

07030-016 FLAT WASHER Stow MS18 Mortar Mixer

974813GT KIT ELECTRIC BOX MOUNTING 2-CC Terex AL5 Light Tower

15010-K 15010-K KUBOTA EA300NB SPECIAL SPEC. Genuine OEM Small Line Parts

20106 12 VOLT DC RELAY Genuine OEM Small Line Parts

16013-K COUPLING ENGINE (KUBOTA) Genuine OEM Small Line Parts

JLG Wiper Package (Skylight and Rear Wiper) (742)

967883504 HUSQVARNA (A)AY57 6' Pneu.Vib.US Coup.- (4812052062) GENUINE CONCRETE VIBRATORS

JLG Foam-Filled 17.5 x 25 -12PR (1255)

JLG Lifting Hook, Fork Mounted (15,000 lb max. capacity (1644)

17112-3R 3" DIAPHRAGM (RED)..NO HOLES Genuine OEM Small Line Parts

19006 FENDER ASSEMBLY Genuine OEM Small Line Parts

Marshalltown 1220MP5E1B Mortar/Plaster Mixer, 1220MP, RAM, 5HP Electric 1 PH, 2" Ball Coupler - 27323

90316 Receptacle Panel 3 x 5-20R 1 x L14-30R 2 x L14-50 Generac Magnum MLG15-MLG20 Mobile Diesel Generator

Morrison 23907 Kit 16' Uni - Screed Blade 4.9M Bartell

HW0001-LOCK NUT 1/4-20 UNC Miller Curber MC550 Curb Machine

Husqvarna Smart E 48 Concrete Vibrator 967940208,Pokers, 110V, 1PH, 50/60Hz, Electric

42310 97200 Pipe Exhaust Airman SDG40S-8B1 Generator

HW0001-HHCS 1/4-20 UNC x 1-1/2" LG. Miller Curber MC550 Curb Machine

Backhoe Bucket, 12" Standard 408 (Edge #500303)

Skyjack Grip Lug Foam-Filled Non-Marking Tires For SJ45 T+ Only

Grapple, Bucket 78" Heavy-Duty (Loflin B-78)

839244GT KUBOTA HEAD COVER GASKET Terex AL4 Light Tower

0578008-20 NUT M8 X 20 GB5780 TK Equipment MVP125 Plate Compactor

Stone Lift Jockey Assembly Column, 7' 6" (Stone 36888)

Whiteman/Multiquip HHN31VTCSL5 Ride-On Power Trowel, Non-Overlapping 92"

Skyjack Tool Tray

JLG Dual Fork Positioning Carriage, 48 in (G5-18A)

Multiquip GAW135HNC Welder/Generator, Welder 135A, 1.5kW Gen Honda, NON-CARB COMPLIANT

AlturnaMATS PAD36362 36" x 36" x 2" Outrigger Pad

Diamond-Insert Rental MBC1 for Alpha Grinder (Set of 4) C09B

Bil-Jax 5533 A DC Trailer Mounted Boom 55'

Grinder Carbide Inserts Rental Set of 2 Assy. (Edco Strip-Serts) C5CD

Diamond-Insert Rental PCD Plate for Alpha Grinder (Set of 4) C9PR

Contec 8727358015US (27-35-80-15-US) Bull Blade U-Shape 350 mm Self Dicing Bartell

Wireless Remote Control (Fits Mayco C30-HDZ Diesel Pump)

JLG G5-18A Package 2 Compact Forklift Telehandler 18 ft 4 in Lift Height W/ All Standard Equipment

JLG Stock Picking Tool Tray

Bartell SA1410WK Water Kit For SM1410

Little Wonder Optimax Blower 9570-04-01 Walk-Behind 18HP Vanguard

Jackhammer Trolley Rental (Makinex JHT) **** Hammer Not Included **** H35C

JLG 943 Package 4 Forklift Telehandler 43 ft Lift Height W/ Enclosed Cab

Bil-Jax 0127-105-18 18" Wide Outrigger (w/#2Pkg.)

Airman Generator, Towable Diesel 150KVA SDG150S-8B1

Chisel, 12" Moil Point, 3/4" Hex/Spline Drive

Marshalltown 1200MP8HBO Mortar/Plaster Mixer, 1200MP, GX240 Honda, 2" Ball Coupler & Outriggers - 27292

AlturnaMATS PAD18181 18" x 18" x 1" Outrigger Pad

Contec CTDTORNADO Tornado Dust Collector - 230 volt - 3 phase Bartell

Genie Telehandler 72 in. QA carriage

Rock Drill Bits and Shanks all Sizes

20" Heavy Duty Floor Sanding Driver Rental FBSD


Manufacturer/Brand


Equipment Type




Over 32 Years of Serving the Industry